GE Multilink ML3000 - Page 195

CHAPTER 11: VLAN REGISTRATION OVER GARP VLAN REGISTRATION OVER GARP
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 11–7
Example 11-2: Configuring GVRP
ML3000# gvrp
ML3000(gvrp)# show gvrp
GVRP Status : Enabled
ML3000(gvrp)## gvrp disable
GVRP is now disabled
ML3000(gvrp)## gvrp enable
GVRP enabled
ML3000(gvrp)## show-vlan
=================================================
VLAN ID | NAME | VLAN | STATUS
=================================================
1 | Default VLAN | Static | Active
2 | Blue | Static | Active
10 | dyn10 | Dynamic | Active
ML3000(gvrp)## static vlan=10
ML3000(gvrp)## show-vlan
=================================================
VLAN ID | NAME | VLAN | STATUS
=================================================
1 | Default VLAN | Static | Active
2 | Blue | Static | Active
10 | dyn10 | Static | Active
ML3000(gvrp)## set-forbid vlan=2 forbid=11-15
ML3000(gvrp)## show-forbid
============================================
VLAN ID | FORBIDDEN PORTS
============================================
1| None