GE Multilink ML3000 User Manual

12–2 MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
SPANNING TREE PROTOCOL (STP) CHAPTER 12: SPANNING TREE PROTOCOL (STP)
The table below lists the default values of the STP variables. Refer to the following section
for detailed explanation on the variables. By default, STP is disabled. To use STP, it has to be
manually enabled.
Table 12–1: STP default values
Variable or attribute Default value
STP capabilities Disabled
Reconfiguring general operation priority 32768
Bridge maximum age 20 seconds
Hello time 2 seconds
Forward delay 15 seconds
Reconfiguring per-port STP path cost 0
Priority 32768
Mode Normal
Monitoring of STP Not available
Root Port Not set

GE Multilink ML3000 Specifications

General

Brand	GE
Model	Multilink ML3000
Category	Network Router
Language	English