GE Multilink ML3000 - Page 223

CHAPTER 13: RAPID SPANNING TREE PROTOCOL RAPID SPANNING TREE PROTOCOL
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 13–15
The sequence of commands for enabling ring-only mode is shown in the following
example:
Example 13-5: Configuring smart RSTP, ring-only mode
ML3000# rstp
ML3000(rstp)##rstp enable
Successfully set the RSTP status
ML3000(rstp)##romode show
RO-MODE status : Disabled
RO-MODE set on ports : NONE
ML3000(rstp)##romode add port=1,2
Added Ports: 1,2
ML3000(rstp)##romode enable
RSTP Ring Only Mode Enabled.
ML3000(rstp)##romode show
RO-MODE status : Enabled
RO-MODE set on ports : 1,2
ML3000(rstp)##romode disable
RSTP Ring Only Mode Disabled.