GE Optica - Serial Output Data

January 2006
4-18 Programming the VGA Optica
Serial Output Data
Table 4-15: Serial Output Data Options
Item Function Available Options
Selected
Outputs
The units of currently selected parameters are
shown, along with the number of decimals for each
unit.
Units of selected output are
displayed. Select one with the
UP/DOWN keys to change it or
delete it using REMOVE.
Time Stamp* Output date and time with each data string. Enabled/Disabled
Show Status*
Output dew point sensor status with each data string
(Heat, Cool, Balance, PACER, Service, Alarm 1,
Alarm 2).
Enabled/Disabled
Parameter Select a parameter to configure.
Humidity, Temperature, Pres-
sure or User Equation
Units Set the units for the selected parameter.
See Table 4-1 on page 4-4 for
available units.
Format* Choose output format for the selected parameter. Dp=##.#, ###.#(Dp), No Label
Separator* Choose separator to be used between parameters. Space, Comma, TAB, CR, CR-LF
Terminator* Choose the terminator(s) for each group of data. Comma, CR, CR-LF
Interval (sec)* Enter the output interval in seconds. Enter a number.
Decimals
Enter the number of decimal places for the selected
parameter.
Enter a number (6 maximum).
ADD button
Control button to add the configured parameter to
the output list, using the units and number of
decimals designated.
Select button and press ENTER.
REMOVE
button
Control button to remove from the output list the
parameter selected at the top of the serial output
menu.
Select button and press ENTER