Programming the VGA Optica 4-19
January 2006
Set Time & Date The Time and Date menu is accessed by selecting Set Time and
Date on Menu 2, and pressing ENTER.
To set the Optica’s internal clock, press TAB to select each field of
the date and time, and press the up and down softkeys to set each
field. When the settings are correct, tab to the OK button and press
ENTER.
Figure 4-8: Time and Date
Restore Defaults To access this choice, select the Restore Defaults button on Menu 2,
and press ENTER.
This screen resets all programmable items to the factory defaults
shown in Table 3-2 on page 3-9. Press TAB to select Yes, and press the
ENTER key.
To Next Page
Loading...
