GE Optica - Data Fields; Pressure Input

Programming the 4x40 Optica 5-7
January 2006
Data Fields
Pressure Input
Table 5-7: Data Field Options
Setting Description Available Options
Line 1 Parameter
Choose which parameter will be
output on Line 1.
Humidity, Temperature, Pressure or
User
Line 1 Units
Set the units for the selected
parameter.
See Table 4-1 on page 4-4 for the
parameter chosen.
Line 1 Decimals
Enter the number of decimal places
for displayed data.
Enter a number (0-6).
Line 2 Parameter
Choose which parameter will be
output on Line 2.
Humidity, Temperature, Pressure or
User
Line 2 Units
Set the units for the selected
parameter.
See Table 4-1 on page 4-4 for the
parameter chosen.
Line 2 Decimals
Enter the number of decimal places
for displayed data.
Enter a number (0-6).
Line 3 Parameter
Choose which parameter will be
output on Line 3.
Humidity, Temperature, Pressure or
User
Line 3 Units
Set the units for the selected
parameter.
See Table 4-1 on page 4-4 for the
parameter chosen.
Line 3 Decimals
Enter the number of decimal places
for displayed data.
Enter a number (0-6).
Table 5-8: Pressure Input Options
Setting Description Available Options
Analog Input #
Choose which pressure input channel
is in use, or disable this input.
4-20 mA, 0-5 volt, User Default
Input Units Choose the units for pressure units. See Table 4-1 on page 4-4 for units.
Input Upper
Set the pressure that corresponds to
full-scale input.
Enter a number.
Input Lower
Set the pressure that corresponds to
zero volts or 4 mA input.
Enter a number.
Input Default
Pressure value to be used if a
measured input is disabled.
Enter a number.
Process Pressure
Default
Set whether the process pressure is
active (enabled) (see page 3-4).
Enabled/Disabled
Process Pressure
Enter the process pressure (if this
feature is enabled).
Enabled/Disabled