GE Optica - Serial Output Units; Serial Output Setup

Programming the 4x40 Optica 5-5
January 2006
Serial Output Units
Serial Output Setup
Table 5-4: Serial Output Unit Options
Setting Description Available Options
Humidity Units* Set the units for humidity.
See Table 4-1 on page 4-4 for the
parameter chosen.
Temperature Units* Set the units for temperature.
See Table 4-1 on page 4-4 for the
parameter chosen.
Pressure Units* Set the units for pressure.
See Table 4-1 on page 4-4 for the
parameter chosen.
User Units* Set the selected user equation.
Choose from any available User
Equation.
*Note: The TAB key selects or deselects the desired output units. If selected, the number of decimals can
be set using a keypad entry (0-6).
Table 5-5: Serial Output Setup Options
Setting Description Available Options
Format
Choose the output format for the
selected parameter.
For humidity, e.g., Dp=##.#, ###.#(Dp),
No Prompt
Field Separator
Choose the separator to be used
between parameters.
Space, Comma, Tab, CR, CR-LF
Record Terminator
Choose the terminator(s) for each
group of data.
Comma, CR, CR-LF
Interval in seconds
Enter the output interval in seconds
(for Serial Mode: All).
Enter a number.
Show Status*
Output dew point sensor status with
each data string (Heat, Cool, Balance,
PACER, Service, Alarm 1, Alarm2).
Enabled/Disabled
Time Stamp
Output date and time with each data
string.
Enabled/Disabled