Programming Meter Settings 6-19
August 2003
Setting up User Tables (cont.)
Note: It is not necessary to enter the “#Data Points” or “Max
Points” text boxes.
4. The final prompt asks you to enter or change data in the user
table.
a. Press
[ENTER] to open the window. The screen appears
similar to Figure 6-12 below.
Figure 6-10: The Edit User Table Window
b. Use the four arrow keys to move to the desired entry in the
table.
c. Press
[ENTER]. Then use the numeric keys to enter the
desired data, which appears in the right corner of the
window above the table.
d. Press
[ENTER] to confirm the data, which then appears in
the appropriate slot in the table.
Programming
Edit User Table 1
Cancell
OK
UserTable1
Y
1
2
3
4
5
To Next Page
Loading...
