GE PM880 - Page 129

Logging Data 7-7
August 2003
Setting up a New Log (cont.)
a. Press [ENTER] to enter the text box. The meter highlights
the first number. Use the [
W] and [X] keys to scroll to any
number you wish to change, or the [
X] key to scroll to the
time box.
b. Two alternatives are available to change a highlighted
number:
• Use the numeric keys to enter the desired number.
• Use the [T] or [S] arrow keys to scroll, in 1-digit
increments, to the desired number. (For example, if the
text box displays 09, pressing the [
T] key twice
changes the number to 07.) You can scroll from 01 to 12
for the month and from 01 to 31 for the day (depending
on the number you have selected for the month).
c. In either case, press
[ENTER] to confirm the entry.
4. Follow the same procedure to enter the end date and time.
Note: If you have selected a circular log in Step 1, the End Date
and Time boxes do not appear. Instead, a text box asks for
the number of records desired. Enter the desired number
and press
[ENTER].
5. The final prompt in this window asks for the logging interval.
a. Press
[ENTER] to open the text box.
b. Use the numeric keys to enter the desired interval in
seconds.
c. Press
[ENTER] to confirm the entry.
6. You have completed entering parameters in this window. To
select the measurements,
a. Press the [
T] key to return to the Format prompt.
b. Then press the [
S] key to return to the General tab.
c. Finally, press the [
X] key to move to the Measurements
tab, and press
[ENTER]. The Measurements window
appears similar to Figure 7-6 on page 7-8.