SAFETY SECTION
1 Chapter Overview
This chapter provides information about the safe handling of the equipment. The equipment must be properly
installed and handled in order to maintain it in a safe condition and to keep personnel safe at all times. You
must be familiar with information contained in this chapter before unpacking, installing, commissioning, or
servicing the equipment.
2 Health and Safety
Personnel associated with the equipment must be familiar with the contents of this Safety Information.
When electrical equipment is in operation, dangerous voltages are present in certain parts of the equipment.
Improper use of the equipment and failure to observe warning notices will endanger personnel.
Only qualified personnel may work on or operate the equipment. Qualified personnel are individuals who
are:
familiar with the installation, commissioning, and operation of the equipment and the system to which it
is being connected.
familiar with accepted safety engineering practises and are authorised to energise and de-energise
equipment in the correct manner.
trained in the care and use of safety apparatus in accordance with safety engineering practises
trained in emergency procedures (first aid).
The documentation provides instructions for installing, commissioning and operating the equipment. It
cannot, however cover all conceivable circumstances. In the event of questions or problems, do not take any
action without proper authorisation. Please contact your local sales office and request the necessary
information.
Each product is subjected to routine production testing for Dielectric Strength and Protective Bonding Continuity
3 Symbols
Throughout this manual you will come across the following symbols. You will also see these symbols on
parts of the equipment.
Caution: Refer to equipment documentation. Failure to do so could result in damage to the
equipment
To Next Page
Loading...
Need help?
General
