4.5 PTP Configuration
The PTP section of the Web Interface, shown in Figure 32, allows the user to configure synchronism
parameters using PTP protocol. This setting is possible only for port ethernet 1.
Figure 32: Section to configure PTP parameters
4.5.1 Profile
RT430 has a set of features attributed to the application of PTP protocol, which the IEEE1588 standard
assigns the name of Profile. The unit provides 3 distinct ways to configure its Profile:
Power Profile: profile with all predetermined characteristics, where the user cannot change any
parameters. The characteristics are shown in its respective fields and are non-editable. The Power
Profile configuration is:
o Domain number 0.
o UDP network protocol.
o Two-step operation mode.
o Mechanism to measure P2P delay.
o Priority 128 in both Ethernet ports.
o Operation as master only.
o Interval between delay, synchronism and announce messages (to calculate BMC) every 1 second.
To Next Page
Loading...
