Configure manually the computer local network connection to:
TABLE 31: Computer IP address, broadcast, and network mask.
If the unit is not using factory default settings, see Chapter 5 for instructions to visualize the current IP
address via local interface.
After connecting the unit to the computer, see section 3.6 for details about accessing the unit.
To check if the unit is accessible, it is possible connect a cross-over network cable to the computer from a
terminal using command line, and run a ping command to the IP address of the unit.
3.5 Communication via Ethernet network
For communication via ETHERNET port, connect one of the ports to the same network the computer is
connected, using a pin-to-pin cable, as shown in Figure 25.
Figure 25: Architecture of communication via Ethernet port
In communication via network, it is necessary the unit and the computer to be in the same local subnet. It is
recommended the ETHERNET port of the unit to be configured by a user to be compatible with a local network,
i.e, the IP address, network mask, gateway, DNS and broadcast should be compatible with the network the
computer is connected to.
To Next Page
Loading...
