For direct communication using the electrical ETHERNET port, connect a 10/100 BaseT cross-over network
cable between the computer and the unit, as shown in Figure 24. The network cable should have the
following pinout:
TABLE 29: Cross-over network cable pinout.
Figure 24: Direct communication architecture using the Ethernet electrical port
In the direct communication with the unit, it is necessary both the computer and the unit connected on the
same local network. To do so, configure the computer network connection according to the unit IP address,
and network mask, as the following example.
RT430 IP address, broadcast and network mask configuration:
TABLE 30: RT430 IP address, broadcast, and network mask.
To Next Page
Loading...
