GE_UPS_OPM_TLE_SCE_M60_M80_1GB_V020.docx
User Manual TLE Series 600 & 800 CE S1
5.2 DELIVERY
When delivered, inspect the package integrity and the physical condition of the cabinets carefully.
In case of any damage sustained during transport, immediately inform the carrier and contact your
local Service Centre.
A detailed report of the damage is necessary for any insurance claim.
NOTE !
A damaged UPS must never be installed or connected to Mains or Battery!
5.3 STORAGE
5.3.1 Storage of the UPS
The equipment is carefully packed for transport and
storage so that it is in a perfect condition when eventually
installed.
Never leave an UPS outside the building and do not store
the UPS one on top of the other.
We recommend to store the UPS in its original package in
a dry, dust-free room, away from chemical substances,
and with a temperature range not exceeding -25°C (-13°F)
to 55°C (131°F).
In case the battery is included please refer to Section 5.3.2.
Some important functions of the UPS, such as the customized functions, are defined by parameters
stored in a RAM memory.
A small backup Battery located on the Control Unit board supplies the RAM.
If the storage time of the UPS exceeds 1 year, these functions should be verified by an authorized
Service Centre before putting the UPS into operation.
5.3.2 Storage of Battery
When the delivery includes a maintenance free Battery, keep in mind that they are subject to self-
discharge and therefore you must recharge the Battery.
The storage time without Battery recharge depends on the temperature of the storage site.
The optimal temperature for Battery storage is 20°C (68°F) to 25°C (77°F) and shall never exceed the
range -20°C (-4°F) to 40°C (104°F).
Recharge stored maintenance free Battery every:
6 months when the storage temperature is 20°C (68°F)
3 months when the storage temperature is 30°C (86°F)
2 months when the storage temperature is 35°C (95°F)
To Next Page
Loading...
