Chapter 2. Instrument Setup
USM Go Operator’s Manual 27
2.3.1d Setting the Date and Time Formats (SETUP-CONFIG1-DATE FORMAT)
1. In the SETUP menu, activate the CONFIG1 submenu using the joystick ( ). Several functions are displayed on the screen.
2. Use the joystick ( ) to select the function titled DATE FORMAT, then press the center of the joystick ( ) to activate the
function.
3. To change the selected date and time format, either move the joystick or press the function toggle. Choose from the following date and
time formats:
• Y-M-D date format and 12 or 24 hour time format
• M/D/Y date format and 12 or 24 hour time format
• D.M.Y date format and 12 or 24 hour time format
4. After making your choice, press the center of the joystick ( ) to deactivate the function. The date and time format shown on the
display screen and in the out reports are now set to the choice last selected.
To Next Page
Loading...
