Chapter 2. Instrument Setup
USM Go Operator’s Manual 39
2.4.2b Specifying the Probe Frequency (RECEIVER-FREQUENCY)
1. In the ACQUIRE menu, activate the RECEIVER submenu using the joystick ( ).
2. Use the joystick ( ) to select the function titled FREQUENCY.
3. To change the specified frequency, move the joystick ( ) or press the function toggle. The following options are available:
• Low Pass, 4, 5, 10, 13 MHz - Choose the frequency that matches the frequency of your probe.
• BROADBAND - Select this option to use the built-in broadband filter.
4. After completing your selection, move the joystick up or down ( ) to navigate away from this function.
To Next Page
Loading...
