A commercial will not be skipped if the recording starts in
the middle of a commercial segment, one isolated
commercial is shown without others, or a commercial is
longer than one minute. Press FWD to scan through the
commercial.
Part of a recorded program may be skipped if the program
segment is between commercials and less than one minute
or there are frequent dark and quiet scenes. If part of the
program is skipped, rewind the tape to the beginning of the
skipped program segment and press PLAY on the remote
(PLAY.PAUSE on VCR).
• Select MANUAL and the VCR won't advance through the
blocks of marked commercials until you press SEARCH.
If you press SEARCHduring playback of material other than
commercials, the VCR advances to the end of the next "marked"
commercial block and resumes playback.
The VCR resumes playback when it reaches the end of the
marked commercials.
COMMERCIALI_ I_ADVANCE Display
Press 3 to switch between Display: BLUE or VIDEO.
• Select BLUE to display a BLUE background when the VCR
advances through the block of marked commercials.
• Select VIDEO to display the recorded video when the VCR
advances through the block of marked commercials.
Marking an Unmarked Tape
This feature allows you to mark an existing tape turning it into
a COMMERClAL_I, ADVANCE tape. The VCR will play the tape
and then mark the commercial segments it finds.
1. Insert a tape that has been previously recorded.
2. Press 4 to select the Mark an unmarked tape feature.
3. Position the tape where you want the marking to start
using PLAY, FWD, and REV buttons.
4O
To Next Page
Loading...
