Residual dangers on the valve and measures
Danger Cause Measure
Danger of injury Danger presented by moving or
sharp-edged parts
The operator must exercise caution and prudence.
For all work:
•
Wear suitable work clothing.
•
Never operate the machine if the cover panels are not
correctly fitted.
•
Never open the cover panels during the operation.
•
Never reach into openings.
As a precautionary measure, wear personal protective equipment
in the vicinity of the valve:
•
Protective gloves
•
Safety shoes
Environmental damage Operating materials with
properties which are harmful to
the environment
For all work:
•
Collect lubricants in suitable containers.
•
Dispose of lubricants in accordance with the pertinent
regulations.
2.9 Hazard Areas
Please observe the following notes:
•
In the event of malfunctions, shut down the valve (disconnect from the power
and air supply) and secure it against being used.
•
When the valve is switching, never reach into pipe Y or into bracket X (on
pneumatic actuators). Fingers can be crushed or cut off.
•
Before starting any service, maintenance or repair work, disconnect the valve
from the power supply and secure it against inadvertently being switched
back on again.
•
Only allow a qualified electrician to carry out any work on the electrical power
supply.
•
Check the electrical equipment of the valve at regular intervals. Immediately
remedy loose connections and molten cables.
Safety
Hazard Areas
430BAL009990EN_2
14 30.01.2018
To Next Page
Loading...
