Generac Power Systems E User Manual

18 Generac
®
Power Systems, Inc.
Section 2 — Operation
E Option Control Panels
E-PANEL DISPLAY MAP
GENERATOR
STATUS
ALARM STATUS ALARM LOG INSTRUMENTATION PARAMETER ENTRY SOFTWARE VERSION GENERATOR COMMAND
Stopped ready to run No active messages * Logged Alarm Number 1 Generator Voltage
XXX Volts
Parameter entry
Press Enter to Continue
Generac digital panel Generator switch off
Software version X.XX Generator switch off
Or Or * this is true as long as Or
or
Or
or
Or Enter Or Enter * Or Turn key to auto mode: Or
there are no messages Generator in auto mode
Thru Hours Run * Display test, stop command
Logged Alarm Number 50 XXXXX.X Hrs all pixels black, all 4 LEDs Turn key to manual mode:
or
will be on Attempting to start
Password Attempt number X
Analog Input 2 XXXXXX
X.X Enter
or
Analog Input 1 Engine Parameter Menu Or System Alarm Menu Or Digital I/O Menu Or Analog Input menu
X.X
or or or or
or
Fuel Level Low Fuel Shutdown Enable Input Ch 8 Alarm Type Analog Ch 2 Low Type
X RS485 Port
or
Direct Connection only
or or or
or
Battery Voltage RS 232 Port Low Fuel Shutdown Setpt Input Ch 8 Alarm enable Analog Ch 2 High Type
XX.X Volts Direct conection XX %
or
or
or or or
RS 232 Port
Oil Pressure Modem connection Fuel Level Low Enable Input Channel 8 Setting Analog Ch 2 Low Enable
XXX p.s.I or
or
RS 232 Port
or or or
Modem connection & Setup
Oil Temperature
or
Fuel Level Low Setpoint Input Channel 8 Message Analog Ch 2 High Enable
XXX deg F XX%
or
Restore all values
or or or
to default settings
Coolant Temperature
or
Fuel Level High Enable Input Ch 7 Alarm Type Analog Ch 2 low Setpoint
XXX deg. F X.X
or
Voltage Scaling Factor
or or or
XXX.XX
Engine Speed
or
Fuel Level High Setpoint Input Ch 7 Alarm Enable Analog Ch 2 High Setpoint
XXXX Rpm XX% X.X
or
Flywheel Teeth
or or or
XXX
Generator Frequency
or
Under Freq Alarm Type Input Channel 7 Setting Analog 2 Low Alarm Msg
XX.XHz
Panel I.D.
or or or
XXXXXX
or
Under Freq Setpoint Input Channel 7 Message Analog Ch 2 High Alarm Msg
XX.X Hz
User Password
or or or
XXXXXX
or
Over Freq Alarm Type Input Ch 6 Alarm Type Analog Channel 2 Title
Preheat Option
or or or
or
Over Freq Setpoint Input Ch 6 Alarm enable Analog Ch 2 Value at 10V
XX.X Hz X.X
Load Accept Frequency
or or or
XX.X Hz
or
Under Voltage Alarm Type Input Channel 6 Setting Analog Ch 2 value at 0V
X.X
Load Accept Voltage
or or or
XXX Volts
or
Under Voltage Setpoint Input Channel 6 Message Analog Ch 1 Low Type
XXX Volts
Starter Disengage Speed
or or or
XXX RPM
or
Over Voltage Alarm Type Input Ch 5 Alarm Type Analog Ch 1 High Type
Number of Start Attempts
or or or
X
or
Over Voltage Setpoint Input Ch 5 Alarm Enable Analog Ch 1 Low Enable
XXX Volts
Generator Cool Down Time
or or or
X Min
E PANEL DISPLAY MAP

Generac Power Systems E Specifications

General

Brand	Generac Power Systems
Model	E
Category	Control Panel
Language	English