Generex CS121L - Figure 49: HTTP - Job Editor: RCCMD Trap, Event Power Restored; Figure 50: HTTP

To Next Page

To Previous Page

#TEMPDEG – Temperature in °Celsius

#AUTONOMTIME – Autonomy time in minutes

#LASTTSTBUPT – Last test battery autonomy time in minutes

#STATUS – Status

#ISTEST – In test mode

#LASTERR – Last error

#TIMEUNTILSHTDWN – Time until shutdown in minutes

#RUNTIME – Runtime in minutes

#INCURR – Input current in A

#BATTVOLT – Battery voltage in V

#INFREQ - Input frequency in Hz

#OUTFREQ – Output frequency in Hz

#CNT_PF – Counter power failures

#CNT_BL – Counter battery low events

#CNT_SD – Counter shutdowns

#CNT_SA – Counter shutdowns active

#CNT_TF – Counter test failures

#INPHASES – Amount input phases

#OUTPHASES – Amount output phases

Example of the configuration of a RCCMD Trap job for the event “Power restored”:

Figure 50: HTTP - Job Editor: RCCMD Trap, Event « Power restored »

You can add any kind of text/measurement units. It is required to add a blank ahead and

behind the variable (#MODEL). If you want to receive more variables, please seperate them

with a blank and a « . ».

Powerfail on #MODEL restored. Battery Capacity #BATTCAP %. Input

Voltage #INVOLT V.

The RCCMD Trap would be received like that :

Generex CS121L - Figure 49: HTTP - Job Editor: RCCMD Trap, Event Power Restored; Figure 50: HTTP - Job Editor: RCCMD TRAP