11
Loose cable is a hidden trouble to electrical safety. After
clamped, check each cable to ensure electrical safety;
It is not allowed to leave any wire clip bending towards
bonding points;
Bind each cable to its designated position;
It is not allowed to lay a cable to end or a sharp corner on
frame;
It is not allowed to lay a cable to end of a bolt or screw;
When laying a cable, keep it away from any heat source or
any place where may bite it when it is moving;
When laying a cable along a handle, avoid it being strained
too tightly or loosely and it can not interfere with any
adjacent part at any turning point;
All cables should be laid smoothly without twist or knot;
Before butt-jointing a connector, check if its sheath has been
damaged and if it is overstretched;
If a cable is at a sharp corner or outer corner, use tape or hose
to protect it;
After a cable is repaired, use tape to bind it securely;
Keep all control cables from bend or twist because dumb
control will result in case any control cable is damaged.
To Next Page
Loading...
