71
1.3 Battery
1.3.1 Disassembly of the battery
Open the battery-cell lid.
Dismantle the clamping bar components of battery cell.
Disassemble the negative wire and then the positive wire.
Take out the battery.
Warning!
In the disassembly of positive pole the tools mustn't contact
the frame because the short-circuit spark will ignite gasoline
and damage the battery.
Installation is conducted in the reverse order of disassembly.
*Attention
In order to prevent short circuit, connect positive pole first before the negative pole.
Please do not disconnect battery when you perform overall lineup; otherwise, internal damage of complete vehicle
components may result.
Inspect the charging state（open-circuit voltage）.
Open the battery-cell lid. Dismantle the clamping bar components of battery cell.
Remove the joint wire of storage cell.
Measure the voltage between battery terminals.
Fully charged：13.1V
Undercharged ：12.3V （The battery does not work for an hour）
*Attention
Inspection of charging state must be performed with a
voltage meter.
To Next Page
Loading...
