124
Remove components of the front cover.
Remove components of left/right switch combination.
Remove components of fuel pump.
Remove the left holding bar, and components of the fuel control bar.
Loose screw bolts of welded components of the steering bar.
Remove the welded components of the steering bar.
7.4.2 Installation
*Note：see P88 for figure for dismantling and mounting steering bar。
Mounting should follow the reversed procedure of dismantling。
Screw bolts of welded components of the steering bar
Value of Torsion：40-60 N·m
7.5 Front fork
7.5.1 Disassembly
Disassemble the front wheel.
Remove the shielding plate for vehicle body.
Remove braking fluid tube, wires of odometer.
Remove steering bar.
Remove in sequence the fastening bolts（4）, anti-sliding washer.
Remove the upside and downside steel bowl and steel balls（7）of the upside axle.
Remove the front fork.
Remove the upside and downside steel bowl（8, 9）and steel balls（7）of the downside axle.
Loose screw bolts of front shock absorber, and springs.
Remove both left and right components（1, 2）of front shock absorber.
Tools：
Wrench for screw bolts of welded components of the steering bar.
Fixing nut spanner.
Specific dismounting tools for bearing steel bowl.
*Attention
Clean the opening part of the body guard board with rags.
Use specialized tools for dismantling the upside and downside steel bowl of axle.
7.5.3 Installation
Lubricate the downside axle steel bowl with grease and confirm the amounts of steel balls.（21pcs）
To Next Page
Loading...
