List of Figures
xi
Geodesic Sensor Net Technical Manual
S-MAN-200-GSNR-001 • January 31, 2007
6-21 Secure the Y clip to the collar
74
6-22 Initial removal of the Net from the subject’s face
75
6-23 Peeling the Net from the subject’s face
76
chapter 8
Connectivities
8-1 Multicontact Hypertronics receptacle (128-channel Net Amps 200
amplifier)
84
8-2 Hypertronics plug of 128-channel GSN
84
8-3 Hypertronics plug released (left) and locked (right)
85
8-4 Magnified view of Hypertac pin and sleeve
86
8-5 Plugging GSN into the GSNIC and the articulated arm
86
8-6 Schematic view of GSN connectors
87
chapter 9
Replacing GSN Parts
9-1 Electrode-replacement kit
89
9-2 Tools needed for replacing electrodes
90
9-3 Remove the handle on the Hypertronics plug
91
9-4 Remove the hood
91
9-5 Remove the screws and slide the clamp out
91
9-6 Let the wires hang loose
92
9-7 Remove the flat black end
92
9-8 Note the numbers and letters marked on the connector
92
9-9 Remove the contact using the extraction tool
93
9-10 Push the tool until the contact pin slides out
93
9-11 Use a pair of needle-nose pliers to grip the contact and pull it out
94
9-12 Enlarged view of Hypertronics contact
95
9-13 View of connector before inserting contact
95
9-14 Replace the hood without crimping the wires
96
9-15 Replacement sponges
97
9-16 In the empty pedestal, place the sponge upright
97
9-17 Push the sponge in firmly
98
9-18 Hydrate and again push the sponge in
98
9-19 A poorly seated sponge
99
To Next Page
Loading...