Geodesic Sensor Net - Push the Sponge in Firmly; Hydrate and Again Push the Sponge in

9: Replacing GSN Parts
98
Geodesic Sensor Net Technical Manual S-MAN-200-GSNR-001 • January 31, 2007
3 Use your thumb to press the sponge firmly into the pedestal (Figure 9-17).
4 Use a pipette to wet the sponge with water and hold the sponge in place with
your thumb while it hydrates.
5 Use your thumb or index finger to press the hydrated sponge farther into the
pedestal (Figure 9-18).
6 Repeat Steps 4–5, until the sponge is firmly seated in the pedestal.
Figure 9-17. Push the sponge in firmly
Figure 9-18. Hydrate and again push the sponge in
Wet the sponge and hold down with
your thumb
Push the wet sponge firmly into the
pedestal