6: Applying the GSN
77
Geodesic Sensor Net Technical Manual
S-MAN-200-GSNR-001 • January 31, 2007
7
After the Net is removed, let the sensor end drop free while you hold the
connector. The Net should hang freely.
8
Careful attention to this removal procedure will prevent wires from becoming
tangled and will make the Net easier to clean and apply next time.
9
The GSN 200 has been constructed with a sliding wire guide to help keep the
electrode wires tangle free. Anytime the Net is not being applied to a subject,
including during rinsing and disinfecting (see “Caring for Your GSN” on page
52), the wire guide should be slid down toward the sensor array. When
applying the GSN 200 to a subject, slide the wire guide up toward the
connector and apply the Net in the usual manner. (The HCGSN wires are
organized with a sleek wrap, which keeps them from tangling.)
10
Follow the instructions in Chapter 7 to disinfect and rinse the Net, then hang it
over the drying rack with the connector higher than the sensors. Do not
package or transport damp Nets. Do not get the Hypertronics connector wet.
To Next Page
Loading...