2.7.17
DATA LOGGING CHAPTER 7 GEODIMETER SYSTEM 600
Instrument with Keyboard unit Card Memory
Connect the instruments tribrach contact and the Card
Memory via the cable 571 202 188/216. Turn on the instru-
ment and enter program 54. Choose (From Xmem, To
Imem) if you are going to transfer data from the Card
memory to the instrument or (From Imem, To Xmem) if you
are going to transfer data from the instrument to the Card
memory. See more information about program 54 at page
2.7.18.
Card Memory Personal Computer
Connect the Card Memory and the computer to a battery via
the multifunctional cable 571 202 188/216 and the computer
adapter 571 202 204 and turn on the computer. There is one
ways to transfer data between these units:
RS-232 commands
By sending the appropriate commands from the computer
you can transfer data between the Card Memory and com-
puter. Look at page 2.7.10 for a list of serial commands or
see the Geodimeter Software & Data communication manual
for further information.
To Next Page
Loading...