2.10.3
CARE & MAINTENANCE CHAPTER 10
GEODIMETER SYSTEM 600
Packing for Transport
The instrument should always be transported in its transport
case, which should be locked.
For shipment to a service shop, the names of the sender and
the receiver should always be specified clearly on the trans-
port case.
When sending this instrument for repair, or for other service
work, a note describing fault, symptoms or requested service
should always be enclosed in the transport case.
Condensation
After survey in moist weather the instrument should be taken
indoors, the transport case opened and the instrument remo-
ved. It should then be left to dry naturally. It is recommended
that condensation which forms on lenses should be allowed
to evaporate naturally.
Warranty
Spectra Precision AB guarantees that the Geodimeter instru-
ment has been inspected and tested before delivery. The
length of the warranty is stated in the Warranty Conditions.
All enquiries regarding the warranty should be directed to
the local Geodimeter representative.
Cleaning
Caution must be exercised when the instrument is cleaned,
especially when sand and dust are to be removed from lenses
and reflectors. Never use coarse or dirty cloth or hard paper.
Anti-static lens paper, cotton wad or lens brush are
recommended. Never use strong detergents such as benzine
or thinner on instrument or case.
To Next Page
Loading...