1.1.20
INTRODUCTION CHAPTER 1
GEODIMETER SYSTEM 600
Activates keyboard operations and turns display table pages,
a switch of face or a compensator initiation.
Enter key
Clear key
For correction of keyed in but not entered errors and to
break a search routine,
or
Standard mode key
Choice of Standard Mode. This key activates the Standard
Measuring Mode. The instrument automatically assumes the
STD mode after going through the Startup Procedure. Stan-
dard Mode is described in detail on page 1.4.2 and in the
"yellow pages", 2.2.4. See also Fast Standard mode on page
1.4.7 and 2.2.5.
or
Tracking mode key
Choice of Tracking Mode. This key activates the tracking
measurements (continuous measurements). Tracking Mode is
described in detail on page 1.4.21 and in the "yellow pages",
2.2.6.
or
Choice of Automatic Arithmetical Mean Value Mode. D -
bar mode is described in detail on page 1.4.8 and in the
"yellow pages", 2.2.5.
D-bar mode key
ENT
STD
TRK
1
2
3
D
STD
TRK
D
To Next Page
Loading...