1.1.25
INTRODUCTION CHAPTER 1
GEODIMETER SYSTEM 600
Continue key
Continue key. With a press on this key you can leave the
editor if you are working with an alphanumeric keyboard.
In some of the internal softwares, this key can be used for
exit the program.
Together with the PWR-key, this key reboots the keyboard
unit, see page 1.6.4.
Temporary horizontal angle key (only in Program 0)
The temporary horizontal angle feature in Program 0 can be
useful if you want to turn the instrument without affecting
the original HA. This function is called HA_L, Horizontal
Angle from a Line, and results in an extra line in the display
showing HA_L=0.0000. You activate the HA_L function by
pressing key 5 in Program 0. Reset HA_L by pressing key 5
again. Exit HA_L with a long press on key 5. Note that this
function only works in Program 0.
CON
5
5
or
To Next Page
Loading...