1.2.4
PRE-MEASUREMENT CHAPTER 2
GEODIMETER SYSTEM 600
ENT
ENT
ENT
22
ENT
F
.....display of the electronic level which
indicates the level status of both axes
of the instrument. As no measurements
are to be made we will disconnect the
dual axis compensator by setting
function 22 to 0.
As no measurements are to be made,
press only ENT.
As no measurements are to be made,
press only ENT.
As no measurements are to be made,
press only ENT.
As no measurements are to be made,
press only ENT.
From previous page
P0 18:20
Temp =20
P0 18:20
Press =760.0
P0 18:20
RelHum =60.0
See next page
ENT
P0 18:20
Offset =0.000
Note!
☛
This menu
is shown
only if
"PPM
Adv." is
activated
in
MNU6.1
To Next Page
Loading...