1.2.17
PRE-MEASUREMENT CHAPTER 2
GEODIMETER SYSTEM 600
ENT
ENT
ENT
ENT
Config. 11:22
Targ.test on
Pcode on?
Config. 11:22
Targ.test on
Pcode on
Info ack. on?
For activation/deactivation of the
Target test; answer ENT/NO.
For more information see "yellow
pages" 2.2.8.
When using the additional software
Pcode, this allows you to switch the
Pcode-table off.
If you want to confirm any info
message that may appear switch this
label on. Any info message will then be
followed by "Press any key". The
display returns to normal after 3s.
If the station height has been establis-
hed in e.g. P20 (Station Establishment)
you can by entering menu 61 from P0
choose whether to include the station
height or not.
Eight different switches can be set in the instrument, by using
the menu's CONFIG function, Option 6, Set switches. You
switch between on and off by pressing the NO key.
Switches ( Targ. test on ?, Pcode on ?, Info ack off ?, HT_meas on ?,
Pow.save on ?, Key click on ?, Prg_num. ?, PPM ADV.?)
Config. 11:22
Targ.test on?
See next page
MNU
6
1
Note!
☛
HT_meas
will not be
displayed
if the
station has
not been
estab-
lished.
Config. 11:22
HT_meas on?
To Next Page
Loading...