1.2.18
PRE-MEASUREMENT CHAPTER 2
GEODIMETER SYSTEM 600
ENT
ENT
From previous page
Config. 11:22
HT_meas on
Pow. save on?
The distance meter can be set in power
save, which means that the distance
meter is only active during distance
measurement given. This is indicated
in the display with an "s". (only in
STD and D-bar)
Set keyclick on to hear a clicking
sound every time you press a key.
If Prg_num is on, the current program
number will be stored first in the
jobfile when you start a program
(P20-P29).
Enabling PPM Adv. means that you
base the PPM correction factor also
on user defined wet temperature or
humidity. Select alternative using
MNU65, Units. If disabled the system
uses a standard humidity of 60% for
the PPM calculation.
Config. 11:22
HT_meas on
Pow. save on
Key click on?
Note-Target Test
The Target Test is created for your safety. It prevents you from
storing an old distance with new angle values. When the target test
is set to off, there is a risk of this, if you forget to measure a
distance when measuring the following points.
Note!
☛
Config. 11:22
Prg_num on?
ENT
Config. 11:22
Prg_num on
PPM Adv. on?
To Next Page
Loading...