138
[IPv6 Settings]
Select Enable IPv6 and click Apply to enable this function.
Note this function is only available for Target firmware V1.07 or later (GV-
EBL1100 / 2100 Series, GV-EBX1100 / 2100 Series, GV-EDR1100 / 2100
Series, GV-EFD1100 / 2100 Series) and Target firmware V1.03 or later
(GV-EVD2100 / 3100 / 5100, GV-EFD2101 / 3101 / 5101 and GV-
EBL5101).
Dynamic IP address: The network environment has a DHCP server
which will automatically assign a dynamic IP address to the camera.
Static IP address: Assign a static IP or fixed IP to the camera and fill
out the required settings.
Note: To enable this function, make sure your network environment
and hardware specifications support IPv6.
For details on Dynamic DNS Server Settings, see 4.8.3 Advanced TCP/IP.
To Next Page
Loading...
Need help?
General