45
The following table describes the configurable items.
Item Description
Physical buttons
P1 button
To assign a function or app to a hardware button on
your device. Tap a button name and select from the
available options in the popup menu.
P2 button
(+) Plus Button
(-) Minus Button
Physical buttons
backlight
To determine the behavior of the physical buttons
backlight. You can have the backlight always off or
always on. You can also have the backlight light up
for a few seconds after a key is pressed.
LTE
All support
firmware
To select the LTE module firmware that matches your
mobile network operator. If your operator is not listed
in the menu, select GENERIC.
Global Navigation Satellite System
GNSS receiver To enable or disable the below systems.
GLONASS
SBAS
To clear all GPS data in memory and restart the GPS
positioning, tap Cold start. The on/off switch will
turn back to the off position when you exit this
setting screen.
Touchscreen
Mode To select the touchscreen mode. Options are:
Touch: This mode works best with fingertip. Select
this when liquids (such as raindrops) are falling on
the screen and should be rejected as input. Use
your finger in this mode.
Pen: This is the default setting. Select this if you
are using the stylus. This mode responds to finger
touches as well.
To Next Page
Loading...
