Gewa G3 - Page 139

G3 – Owner‘s Manual | 139
44rrH
Head/Rim resp. Bow/Edge/Bell*** High Level 8..127
45rrH
Hi-Hat Pedal Low Position 0..127
46rrH
Hi-Hat Pedal High Position 0..127
47rrH
Head/Rim resp. Bow/Edge/Bell*** Scan Time 10..100
48rrH
Head/Rim resp. Bow/Edge/Bell*** Retrigger Mask 1..127
49rrH
Trigger Type Head/Bow :1 = Single, 2 = Dual, 3 = ”3-way” , Rim/Edge: 0 = Piezo, 1 = Switch
4ArrH
Positional Sensing* 0 = OFF, else ON
4CrrH
Curve preset # ** 0..15
4DrrH
Hi-Hat Pedal Chick Sensitivity 0..127
4ErrH
Hi-Hat Pedal Splash Sensitivity 0..127
4FrrH
Trigger Bank Preset parameter transfer end marker
50rrH
Head/Rim Dyn Level 0..15
51rrH
Head/Rim Dyn Time 0..15 (corresponds to 0-60ms decay time)
*Positional Sensing: SAM5916 sends MIDI Controller CC#16 with value 0 (Center) till 127 (Outer).
** Hi-Hat Pedal curve is select when sending NRPN 0x4C2C (“rr” = 0x2C = “HH Chick” note)
*** Parameter available for Bell only in case of “3-Way” mode selected