GF EA Series User Manual

Help in case of faults Instruction manual
66
10.2 Assignment of error codes
In case of a fault, the error codes will be displayed on the 7 segment display on the base board.
Error code Description “Ready-to-operate”
signal
EA response
----
No voltage No None
U
Voltage below specification No None
O
Housing internal
temperature too high (>80
°C)
No Stops
S
Time from end position
to end position too long (>
120s)
No Stops
Voltage above specification No Stops
Heating defective and T =
< 0 °C
No Normal
operation
e
Error in position detection No None
P
Invalid position No Normal
operation
E
Emergency manual override
active
No None
9
No communication with
accessories
No None
I
Actuator was run in motor
current limit
No Stops
Further error codes can be found in the corresponding accessory user manuals.

GF EA Series Specifications

General

Brand	GF
Model	EA Series
Category	Controller
Language	English