Gill Instruments 1561-PK-020 - Page 57

WindMaster and WindMaster Pro 1561-PS-0001. Issue 11 February 2017
________________________________________________________________________________________________________________________
57
Tx – Set analogue output type
Use Gill Wind Software to set required ranges
1 0V to 5V range
2 –2.5V to 2.5V range
3 4mA to 20mA range
4 –5V to 5V range
5 0mA to 20mA range
Ux – Set units
1 m/s
2 Knots
3 MPH
4 KPH
5 FPM
Vx – Enable/Disable PRT
1 OFF
2 ON
Note: PRT not an Option fitted to the WindMaster.
Xx – Axis Alignment
1 Align U Axis to unit North Spar (See Fig 2).
2 Align U to the top axis transducer 1
3 Same as X1 but inverted for upside down operation
4 Same as X2 but inverted for upside down operation