KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 38-
5006892-01
BA-E
®
Removing the rope rotor
• Use a screwdriver or suitable pliers to remove the spring clip (Pos. 3) from the starter
post.
• Carefully remove the E-clip (Pos. 7).
• Carefully remove the carrier (Pos. 5) with pawls (Pos. 2) and washer (Pos. 8)
and put them to one side so that the pawls and washer cannot fall out.
• Pull the rope rotor (Pos. 9) off the starter post.
If the rewind spring needs to be replaced, continue with “replacing the rewind spring”. If the starter rope needs
to be replaced, continue with the following chapter.
Replacing the starter rope
• Pry the cap out of the starter grip.
• Remove worn rope or remaining rope from the rotor and starter grip.
• Thread the new rope through the starter grip and tie a simple overhand knot in its
end as shown.
• Pull the knot back into the grip.
• Refit the cap in the grip.
• Thread the rope through the top of the guide bushing (Pos. 10) and rope rotor (Pos.
9).
• Tie a simple overhand knot in the end of the rope.
• Pull the knot into the rope rotor. If necessary, push the knot into the rotor’s recess.
Go to “installing the rope rotor”.
Replacing the rewind spring
Attention: The pressure spring may pop out and uncoil during this operation. Take care to
avoid the risk of injury!
Attention: The bits of the spring may still be under tension and could fly apart when you
remove the rope rotor and spring housing. To reduce the risk of injury, wear face protection
and work gloves!
To Next Page
Loading...