KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 39-
5006892-01
BA-E
®
• Take out the screws (Pos. 11).
• Remove the spring housing and spring or bits of the spring.
• Lubricate the new, ready-to-fit replacement spring in the new spring housing with a
few drops of resin-free oil.
• Fit the replacement spring with spring housing - the bottom plate must face up.
• Fit the screws.
Installing the rope rotor
• Coat the whole starter post uniformly - including the grooves (arrow) - with gear lubricant (special
assessor).
• Slip the rotor over the starter post - turn it back and forth to engage the anchor
loop of the rewind spring.
• Slip the carrier with pawls and washer over the starter post - turn it back and
forth to engage the anchor loop of the rewind spring in the carrier.
• Fit the E-clip (Pos. 7) in the grooves in the starter post.
• Push the spring clip (Pos. 3) into position - it must point counter clockwise as shown
and engage the pawls peg.
Tensioning the rewind spring
• Pull the starter rope out of the housing as far as stop and make a loop.
• Fit the tensioning wrench on the carrier.
• Use the tensioning wrench to rotate the rotor six
full turns counter clockwise - the rope winds itself around the tensioning
wrench in this process.
• Hold the tensioning wrench steady and unwind the rope.
• Pull out and straighten the twisted rope at the starter grip.
• Hold the rope steady with the starter grip.
• Release the tensioning wrench and rope slowly so that it winds onto the rotor.
• Remove the tensioning wrench.
The starter grip must locate firmly in the guide bushing. If the grip droops to one side: add one more turn on the
rope rotor to increase spring tension.
Attention: If the spring pops out of the housing during installation: wear face protection and
work gloves and refit the spring in the spring housing - clockwise - from the outside
inwards!
To Next Page
Loading...