S
Sharon BentonSep 8, 2025
What to do if GÖLZ KB 300 has segment too big surface?
- MMary GonzalesSep 8, 2025
If the GÖLZ Drill segment surface is too big, attach a drill bit with less segments, or reduce the rpm and increase the feed compression.
To Next PageTo Next PageWhat to do if GÖLZ KB 300 has segment too big surface?
If the GÖLZ Drill segment surface is too big, attach a drill bit with less segments, or reduce the rpm and increase the feed compression.
What to do if GÖLZ Drill segments to narrow?
If the segments of your GÖLZ Drill are too narrow, use a drill bit with wider segments or reduce feed.
What to do if GÖLZ KB 300 Drill is used with abrasive material?
When working with abrasive material using the GÖLZ Drill, use segments one class harder bonded. Increase the water flow and the speed.
What to do if GÖLZ Drill RPM is too fast?
If the RPM of your GÖLZ Drill is too fast, use a lower RPM.
General