ital TV Receiver
28
GDR11 Digital TV receiver
Important information about searching for new
channels
The receiver gives you two ways to search for new TV and radio
channels.
1 Automatic channel search when the receiver is on
standby
• As new channels and features become available, your receiver
will automatically search for them. This will only happen
when you put the receiver on standby. You will then see
the standby light flash slowly to show that it is searching for
new channels.
• When it has finished searching, the light will stop flashing and
the receiver stays on standby as normal. If you do not put
the receiver on standby after you’ve watched it, you
will not be able to see any new channels that might
become available.
• When you switch the receiver on again, and an automatic
search has been done while it was on standby, you will see a
message saying ‘The list of channels has been changed’. You
can start watching TV by pressing the ‘OK’ button on your
remote control.
2 Automatic channel search from the receiver’s menu
• You can also search for new channels through the receiver’s
menu. To do this, see the instructions on page 59.
To Next Page
Loading...
