ital TV Receiver
82
GDR11 Digital TV receiver
Electrical safety
Read the electrical-safety pages in this guide carefully before
you connect the receiver to the mains supply.
Make sure your electricity supply is the same voltage as the voltage
printed on the label on the bottom of the main unit of your receiver.
The receiver needs a 230-volt (V) 50-hertz (Hz) mains supply. Do not
use any other supply. The receiver comes with a moulded plug. If
the plug breaks, you cannot reuse the plug. If you need to change
the fuse in a moulded plug you must refit the fuse cover. If you lose
or damage the fuse cover, you must not use the plug until you have
a replacement plug cover or plug.
If you have to change the plug because it is not suitable for your
socket, or it is damaged, you should remove it and fit the right plug
using the wiring diagram shown on the next page. You must throw
the plug away safely. You could get an electric shock if you use it
again.
The colours of the wires in the receiver’s power lead may not match
the coloured markings in your plug, so you should follow these
instructions.
• You must connect the blue wire to the terminal marked with
the letter ‘N’ or coloured black.
• You must connect the brown wire to the terminal marked with
the letter ‘L’ or coloured red.
To Next Page
Loading...
