ntpCliVersionNumber ►
Version of this product. It’s something like Vxx.yy (yymmdd) where xx.yy is the
current version of the software, yymmdd is the release date of the software (dd/
mm/yy)
ntpCliSerialNumber ►
Serial number of this product on 6 digits.
ntpCliMAC ►
Hardware address of the Ethernet interface of the LEDI Network IN. This address is
on the form aa:bb:cc:dd:ee (6 binary bytes).
ntpCliMessageString ►
A text that gives the description of the last generated trap. This text is also attached
to the trap.
ntpCliResetInfo ►
A text that indicates why the product has restarted (reconguration or hard reset).
ntpCliSoftwareState ►
This eld gives the current state of the NTP client software. It can take one of the
following values:
Idle: the product has just started. ►
Autodetection: no NTP server has been specied and the product is trying to ►
detect NTP server(s).
Autodetectfail: no NTP server found for synchronization – the product will use a ►
server as soon as you connect a server on your network.
Learning: the software is currently learning network properties. ►
ntpCliSyncMode ►
The synchronization mode currently used. It can be one of the following values:
Autodetect: no NTP server has been specied and the product is trying to detect ►
NTP server(s).
Sync1server: works with only one NTP server. ►
Sync2server: works with two NTP servers. When a server fails, it uses the other ►
one.
Sync3server: works with 3 NTP servers. When a server fails, it uses one of the ►
other servers.
5. SNMP INTERFACE
To Next Page
Loading...