DP750/DP720 Administration Guide
Version 1.0.11.4
• Handset Name: Displays index and name (customizable) of each handset.
• IPEI: Indicates IPEI number of each handset; this is the unique identity for the
handset. If the handset is in range, the IPEI will be displayed with a green
background, otherwise, it will be displayed with a red background.
• Battery icon : Illustrates battery status for each Handset; it can be either:
Fully charged
Not fully charged
Low, needs to be charged or replaced
Charging
• Page: Sends paging request to corresponding handset, which will receive
incoming ring tone and “Paging” will be displayed on their LCD screens; this
function helps you locate the handsets.
• Unsubscribe: Unsubscribes corresponding handset from DECT base station.
• HS Firmware: Indicates handset’s firmware version number.
• Upgrade: Shows handset upgrade status or trigger handset upgrade process.
• RAM Dump: Notifies when a debug file is available after recovery.
• Note: The DECT page status keeps refreshing automatically and periodically
to update the information about the registered handsets.
Displays paired repeaters showing:
Model: Displays model of repeater.
Name: Displays the name of the repeater.
IP address: Displays the DECT repeater IP address.
MAC address: Displays the DECT repeater MAC address.
Status: Displays the status of DECT Repeater:
Online when the repeater is turned on and ready for use.
Offline when the repeater is turned off.
Signal Strength: Display link status and signal strength, different status is
available (excellent, good, week and poor) depending on the distance between
the repeater and base station.
Active Calls: Displays number of active calls.
Unlink: Click on Unlink button to disconnect the DECT Repeater from the base
station.
Displays discovered repeaters using:
Model: Displays model of repeater.
Name: Displays the name of the repeater.
IP address: Displays the DECT repeater IP address.
MAC address: Displays the DECT repeater MAC address.
Link: Clicks Link button to connect DECT Repeater to the base station.