3. Choose which Handsets to locate and press its corresponding Page button.
4. A paging call will be received on the selected DP730/DP722 Handsets.
Note: If you press Page All icon , all registered DP730/DP722 handsets will be receiving paging call.
5. Once located, you can press End Softkey to end paging call.
Figure 15: Locate Handsets via Web UI
Locate via DP752 Base station
1.
On DP752 Base station front side, press Radio/Page button.
2. All registered Handsets will receive Paging call.
3. Once located, you can end the paging calling by pressing any key on the Handsets or by pressing again Radio/Page
button.
Checking System Status
You can view the system status on your handsets including the following information of the system:
Item Description
Firmware Current firmware version installed on DP722/DP730.
IP Address IP address of the base station DP752 if registered.
Subnet Mask Subnet Mask of the base station DP752 if registered.
Gateway Gateway IP of the base station DP752 if registered.
To Next Page
Loading...
Need help?
General
