Using DP722/DP730 Handsets Menu
1. Press Menu to bring up operation menu.
2. Select Preferences 𔪠navigate to Off-Cradle Pickup using the up/down arrow keys.
3. Switch between Enabled/Disabled using left/right arrow keys and āSaveā after Enabling / Disabling the option.
Using DP752 Base Station Web Interface
1. Access DP752 Base Station Web Interface.
2. Go to DECT 𔪠Handsets Settings 𔪠HS# Settings.
3. Set āEnable Onhook on Cradle Repositionā to āYesā. (By default, set to āNoā).
Ending Calls
To terminate the calls, press Hang-Up key .
On-Cradle Hang-up
Users can enable On-Cradle Hang-up feature to automatically end ongoing calls after placing DP722/DP730 Handsets on its
cradle.
To activate / deactivate the on-cradle hang-up feature:
Using DP722/DP730 Handsets Menu
1. Press Menu to bring up operation menu.
2. Select Preferences 𔪠navigate to On-Cradle Hang-up using the up/down arrow keys.
3. Switch between Enabled/Disabled using left/right arrow keys and āSaveā after Enabling / Disabling the option.
Using DP752 Base Station Web Interface
1. Access DP752 Base Station Web Interface.
2. Go to DECT 𔪠Handsets Settings 𔪠HS# Settings.
3. Set āEnable Off hook on Cradle Pickupā to āYesā. (By default, set to āNoā).
Rejecting Calls
To reject an incoming call, press Hang-Up key or āRejectā softkey (right softkey)
Direct IP Call
Direct IP calling allows two parties, that is, a handsets and another VoIP device, to talk to each other in an ad hoc fashion
without a SIP proxy.
Elements necessary to complete a Direct IP Call:
Both DP722/DP730 and other VoIP Device, have public IP addresses, or
Both DP722/DP730 and other VoIP Device are on the same LAN using private IP addresses, or
Both DP722/DP730 and other VoIP Device can be connected through a router using public or private IP addresses (with
necessary port forwarding or DMZ).
Users can perform IP calls using Star code following the below steps:
1.
Pick up the handsets and press Dial key .
2. Dial *47 followed by the target IP Address.