Grandstream Networks DP752 User Manual

BASIC OPERATIONS
Call Features
● Do Not Disturb:Enable/disable do not disturb mode on the phone.
● Call Forward: Configure call forward feature.
● Call Waiting: Configure call waiting feature.
● Paging: Configures Inter-Handsets paging feature.
Status
● Base Status: Display Base status (Firmware, IP address, Subnet
mask, Gateway, MAC Address)
● Handset Statut: Display Handsets status (Model RF, Firmware,
IPEI)
● Line Status: Display Line status (Account name, Status)
Settings
● Handset Name:Change the Handset name.
● Phone Language: Select the language to be displayed on the
phone’s LCD. (Default is English.)
● Date/Time: Configure date and time on the Handsets.
● Audio: Specify ringtones for internal/external calls, the volume,
advisory tones (Keypad, Confirmation, Low battery notifications)
and Vibration mode (DP730 only).
● Display: Configure backlight, LCD timeout (Idle/Call), LCD
brightness, Message Waiting Prompt and menu key timeout.
● Gestures (DP730 only): Configure Close-to-Ear Backlight and
Facedown Hangup.
● Network Settings: Configure IP addresses and select DHCP/Static
IP mode.
● SIP Settings: Configure/View SIP accounts settings.
● System Settings: Change Base PIN code, perform factory reset,
reboot base and configure repeater mode.
● Firmware Upgrade: Upgrade the firmware version of the
Handsets.
● Factory Functions: Diagnostic Mode (DP722) / Keypad Diagnostic
(DP730)
All LEDs will light up, and the LCD will display a table listing the
names of all keys in red. Press any key to diagnose; the key’s name
will display in blue. After all keys are diagnosed, a prompt message
(“PASS”) will display; press “Back” (right softkey) to exit.
Note:User can long press arrow UP key to exit at any time.
● Audio Loopback: Speak to the phone using
speaker/Handsets/headset. If you can hear your voice, your
audio is working fine. Press “Exit” softkey to exit audio loopback
mode.
● LCD ON / OFF: Select this option to turn off LCD. Press any button
to turn on LCD.
● LCD Diagnostic: Select this option to enter LCD Diagnostic mode.
Press “Next” (left softkey) to display white screen. Continue
pressing the left softkey to view all remaining screens (black,
blue, red, and green) and then exit. End the test early by pressing
the right softkey.
● LED Diagnostic: Enters this option and press “1” to start LED
Diagnostic (you will notice that the color of the LED will be
changing). Press “2” to quit.
● System Monitoring: Displays RSSI, battery voltage and RPN
information.
● Vibration (DP730 only): Test vibration on DP730.
● Acceleration Sensor (DP730):Displays X, Y, Z coordinates.
● Proximity Sensor (DP730): Test proximity sensor on DP730.

Grandstream Networks DP752 Specifications

General

Brand	Grandstream Networks
Model	DP752
Category	IP Phone
Language	English