Table 10: DP722/DP730 Battery Specifications
In order to get the best performance of your DP730/DP722 Handsets, we recommend using original batteries provided in the
package or batteries compliant with above specifications.
Setting up the Charge Station
Please refer to the following steps for setting up the charge station and charging the Handsets:
1. Connect the DC plug on the power adapter to the micro-USB connector on the charge station.
2. Connect the other end of the power adapter into an electrical power outlet.
3. After setting up the Handsets and the charge station, place the Handsets in the charge station.
Figure 6: Setting up Charging Stations
DP752 LED Patterns
The DP752 has 5 LED lights on it. Please refer to the following table for the meaning of each light.
Figure 7: DP752 LED Patterns
LED Light Status
Indicates Power ON/OFF.
Indicates status of SIP account registration and network
Solid ON: SIP account registered.
Blinking: SIP account not registered or network error
Disclaimer
The abovementioned battery specifications can vary and depend on many factors (age of the battery, number of recharge
cycles, real capacity…). The recharge cycles of the battery are limited; thus, it might need to be replaced if the battery
performance is low. The number of charge cycles and battery life are affected by usage and configuration.
Important Note
Be careful when inserting the batteries into your handset to avoid any risk of short-circuit, which lead to damage your batteries
and/or the handset itself. Do not use damaged batteries which can increase the risk of serious harm.
To Next Page
Loading...
Need help?
General
