Examples of direct IP calls
1. If the target IP address is 192.168.0.160, the dialing convention is *47 then 192*168*0*160, followed by pressing the “#”
key if it is configured as a send key or wait 4 seconds. In this case, the default destination port 5060 is used if no port is
specified.
2. If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be: *47 or Voice Prompt with
option 47, then 192*168*0*160*5062 followed by pressing the “#” key if it is configured as a send key or wait for 4
seconds.
Call Hold/Resume
During an established call, you can put the call on hold and resume following below steps:
1. Press the left softkey to access the call Options and then navigate to Hold.
2. Press “Select”, left softkey to put the call on hold.
3. To resume the call, access the options menu again and navigate to Resume, then press Select.
Or you can press the softkey Hold to hold the call and Resume to resume it.
Call Waiting
This feature will notify you of a new incoming call during an established call and display the incoming call information visually
on the LCD screen and a call waiting tone will be heard. If this feature is disabled, the new incoming call will be automatically
rejected.
There are 2 ways to activate call waiting feature either using DP722/DP730 Handsets Menu or using DP752 Base Station Web
Interface.
Using DP722/DP730 Handsets Menu
1. Press Menu to bring up operation menu.
2.
Use arrow keys to reach Call Features 🡪 navigate to Call waiting sub-menu.
3. Select the account for which you want to enable the Call waiting feature, and then press left softkey “Select”.
4. Choose between Enabled and Disabled options and press the softkey “Save”, a prompt message will be displayed to
confirm that the call waiting is enabled / disabled.
5.
During an established call, press (dial key) to put first call on hold and answers second incoming call. If no
second incoming call, pressing will give the ability to initiate another call while first one is on hold.
Using DP752 Base Station Web Interface
1. Access DP752 Base Station Web Interface.
2. Go to DECT 🡪 Handsets Settings 🡪 HS# Settings.
Note
You can enter directly *47 + target IP address, and then press the dial key to initiate the call.
Note
To accept incoming direct IP call, Use Random Port setting should be set to NO. If set to YES, it can only dial out. The setting is
available on DP752 web interface 🡪 Profile 🡪 SIP Settings 🡪 Basic Settings.
Note
You can switch between active/on-hold calls by pressing Options 🡪 Swap.
To Next Page
Loading...
Need help?
General
